Baudismodel, Adolfovice, Jeseník, ČR

Wingspan:	3050mm
Area:	59,4dm2
Aspect ratio:	15,66
Airfoil:	DP
V-tail span:	586mm
V-tail area:	5,64dm2
V-tail aspect ratio:	6,1
V-tail airfoil:	DP
Weight:	2100 ÷ 3400g / 3600g (with lead ballast cubes)
Wing loading:	35 ÷ 57 / 60g / dm2

Differences between F3F and F3B version:

F3F:	- CF 160g on surface of wing - wingspar balsa/carbon sandwich - fuselage without hook - weight: 2400-2500g
F3B:	- CF 68g on the surface of wing - wingspar kevlar honeycomg/carbon sandwich - fuselage with hook
Version 2,4Ghz:	- front part of fuselage without carbon (fibreglass)

Watch instruction videos in video section.

 Manual

For finishing the model you need only RC equipment (servos, reciver...) and 5 minutes epoxy.  

Set conteints:

• Fuselage with canopy and installed towing hook (F3B version)
• Wings with joiner and servo covers (horns already glued)
• V-Tail with joiners (horns already glued)
• Cables for wing servos with connectors (2x 85cm, 2x 30cm)
• Extension cables for wing servos into the fuselage with connectors (4 x 30 cm)
• Two pair of MPX 6-pin connectors
• Servo holders for wing servos with third BB (2x right, 2x left) - Futaba S3150
• Servo holder for V-Tail servos into fuselage – Graupner DS3728/DS3781
• Servo covers
• Two carbon tubes for V-Tail linkage
• M3 metal clevises (8x) with M3 screw rods (4x) for wing linkage
• M2 metal clevises (2x) with 80mm 2mm/M2 wire (2x) for V-tail linkage
• M2 ball pivot (M2) with 130mm 2mm/M2 wire (2x) for V-Tail linkage
• 10pcs brass ballast cubes (16x20x50mm – 130g/1pcs)